Co‐existence of ductile, semi‐ductile, and brittle fractures of polycarbonate

Abstract

AbstractThe ductile–brittle transition behavior of polycarbonate and methylmethacrylate–butadiene–styrene (MBS) elastomer modified polycarbonate has been investigated in terms of notch radius and temperature. At−40°C and 21‐mil notch radius, polycarbonate fractures in three possible modes, ductile (25%), semi‐ductile (50%), and brittle (25%). This semiductile mode fracture has never been reported previously with brittle characterization, but to a greater extent in localized shear yielding on the fracture surface and intermediate toughness. A two‐dimensional fracture mode diagram in terms of temperature and notch radius has been constructed to interpret the observed phenomena. This diagram can also predict the existence of other conditions under which the triplet fracture modes may also occur. Another unstable zone has also been identified where the fracture occurs in either ductile mode or brittle mode over a broad temperature range, instead of the narrow temperature range typically observed for polycarbonate. A model based on the excessive precrack strain just below yielding due to the greater notch radius is proposed to explain such observed semi‐ductile mode fracture.