カルド修飾CNF/PLAコンポジット材料の力学的・熱的物性評価研究(II)

Abstract

In our previous paper, we reported that the cellulose nano-fiber (CNF) treated with Cardo material (BPFG), referred to as B-CNF, dispersed finely in an organic solvent as well as in polylactic acid (PLA) matrix, and the mechanical properties (especially at the temperature region above the grass transition temperature, Tg) of PLA/CNF composites were improved with the amount of B-CNF content (0.3, 0.5, and 1.1 wt%) in the composites. However, the degree of substitution of BPFG on CNF was only 8.6 wt% (18.6 mmol%) and the effect of the substitution of BPFG was not determined. In this study, we prepared several B-CNF with various degrees of substitution to BPFG and examined the effect of the substitution on the mechanical properties of PLA/B-CNF composites. Moreover, we also prepared the CNF treated by Bisphenol-A diglycidyl ether (BPAG), which does not have Cardo structure in its chemical structure, and determined the effect of the difference in chemical structure (with/without Cardo structure) on their mechanical properties at high temperature. Master batches were prepared by mixing CNF and PLA in an organic solvent and then they were further blended with PLA in a kneader at 150 °C. TEM observation revealed that both of the CNF treated with BPFG (B-CNF) and that treated with BPAG (BisA-CNF) dispersed homogeneously in the PLA. The storage moduli of B-CNF/PLA composites above Tg increased with the degree of BPFG substitution. The storage moduli of B-CNF/PLA and BisA-CNF/PLA with similar degree of substitution were about 5 times higher than that of neat PLA above Tg, and the modulus of B-CNF/PLA was slightly higher than that of BisA-CNF/PLA. Moreover, the peak intensity of tanδ of B-CNF/PLA and BisA-CNF/PLA were lower than that of neat PLA, and the intensity of tanδ of B-CNF/PLA was lower than that of BisA-CNF/PLA. These results suggest that the molecular motion of PLA was restricted by the presence of B-CNF and BisA-CNF because the interaction between PLA and B-CNF or BisA-CNF is much stronger than that in untreated CNF/PLA. Furthermore, B-CNF improved the mechanical properties of the composite more effectively than BisA-CNF for the PLA composite above Tg. From the result of Coefficient of Thermal Expansion (CTE) measurements, we estimated the volume fraction of PLA phase interacting with B-CNF and BisA-CNF by means of the “mixtures rule”. As a result, it was found that the PLA phase interacting with of B-CNF/PLA is larger than that in BisA-CNF/PLA. This may be one of the factor which caused the difference in their mechanical properties of B-CNF/PLA and BisA-CNF/PLA. Finally, CTE measurements revealed that there is a strong relation between the intensity of tanδ at Tg and the volume fraction of the PLA interacting phase in PLA matrix.