Abstract
Recent developments in laser joining show the applicability of spectral analysis of the plasma plume emission to monitor and control the quality of weld. The analysis of the complete spectra makes it possible to measure specific emission lines which reveal information about the welding process. The subsequent estimation of the electron temperature can be correlated with the quality of the corresponding weld seam. A typical quality parameter, for laser welds of stainless steel, is the achieved penetration depth of the weld. Furthermore adequate gas shielding of the welds has to be provided to avoid seam oxidation. In this paper monitoring and real-time control of the penetration depth during laser welding is demonstrated. Optical emissions in the range of 400nm and 560nm are collected by a fast spectrometer. The sensor data are used to determinethe weld quality of overlap welds in AISI 304 stainless steel sheets performed both with CW Nd:YAG and CO2 lasers. A PI-controller adjusts the laser power aiming at a constant penetration. Optical inspection of the weld surface and microscopic analysis of weld cross sections were used to verify the results obtained with the proposed closed-loop system of spectroscopic sensor and controller.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call