Cleft lip and palate surgery simulator: Open source simulation model

Abstract

ObjectiveCleft lip and palate is the most common craniofacial birth anomaly and requires surgery in the first year of life. However, craniofacial surgery training opportunities are limited. The aim of this study was to present and evaluate an open-source cleft lip and palate hybrid (casting and three-dimensional (3D) printing) simulation model which can be replicated at low cost to facilitate the teaching and training of cleft surgery anatomy and techniques. DesignThe soft tissue component of the cleft surgery training model was casted using a 3D printed 5-component mold and silicone. The bony structure was designed to simulate the facial anatomy and to hold the silicone soft tissue. Settingand Participants: Two groups, one group of trainees and one group of expert surgeons, at University Hospital Basel in Switzerland and Pontifical Catholic University of Chile in Santiago, Chile, tested the cleft lip and palate simulation model. Participants completed a Likert-based face and content validity questionnaire to assess the realism of the model and its usefulness in surgical training. ResultsMore than 70 % of the participants agreed that the model accurately simulated human tissues found in patients with unilateral cleft lip and palate. Over 60 % of the participants also agreed that the model realistically replicated surgical procedures. In addition, 80–90 % of the participants found the model to be a useful and appropriate tool for teaching surgical trainees the anatomy and surgical techniques involved in performing unilateral cleft lip and palate repair. ConclusionThis open-source protocol provides a cost-effective solution for surgeons to introduce the cleft morphology and surgical techniques to trainees on a regular basis. It addresses the current financial barrier that limits access to commercially available models during the early stages of surgeon training prior to specialization in the field.