Abstract
ABSTRACTDuplex electroless nickel coatings constituted of one layer of nickel-phosphorous and one of nickel-boron are a promising solution to provide combined wear and corrosion resistance to parts. Duplex systems were compared to systems of similar thickness constituted of only one material, in one or two layers. Duplex coatings present intermediate surface texture, but each layer keeps its typical cross-section morphology and structural features, even after heat treatment. The interfaces between the separate layers are sharp in the as-deposited state but not as much after heat treatment. When nickel-boron is deposited first, it influences slightly the grain growth of the subsequent nickel-phosphorous layer, but no influence can be observed when nickel-phosphorous is deposited first.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.