Abstract
The aim of this research has been to demonstrate the use and applicability of substrates containing non-wood fibres in the printing industry, with an emphasis on flexographic printing for packaging. To obtain such substrates, laboratory papers were produced with the addition of 30% non-wood fibres (wheat, barley and triticale), in combination with recycled wood pulp. These substrates were tested for chemical and mechanical resistance after flexographic printing with conventional and ultraviolet curing inks. The results showed that all laboratory papers with the addition of 30% non-wood fibres, printed with water-based inks, had fairly good chemical and mechanical resistance, except for the prints treated with sodium hydroxide. Thus, such papers should not be used as packaging materials for alkaline products. UV-curable inks on these substrates showed low chemical resistance, thus should only be used on substrates intended for secondary packaging. The mechanical resistance of UV prints was very good, thus papers containing straw pulp could be used for various applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.