Abstract
In the present study, correlation of the microstructure and stress corrosion cracking (SCC) susceptibility in the top, middle and root regions of a multi-pass austenitic stainless steel weld joint fabricated by narrow-gap tungsten inert gas welding (NG-TIG) was investigated by slow strain rate tests (SSRT) following a microstructure characterization. The results show that from the top to root regions in both the heat-affected zone (HAZ) and weld metal (WM), the dislocation density and length fraction of the Σ3 boundaries present a decreased trend, while the grain size, length fraction of LAB and residual strain all increase. By comparing the microstructure of WM with HAZ, δ-ferrite in WM is excessive and continuous while that in HAZ is island-shaped and discontinuous. In addition, larger grain size, lower dislocation density, higher residual strain, lower length fraction of Σ3 boundaries and higher length fraction of RGB are observed in WM. As a result, the SCC susceptibility in various regions of the weld joint follows the order of root regions > middle regions > top regions and WM > HAZ.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
