Abstract
Oscillating laser hot-wire tungsten inert gas (TIG) hybrid welding of 10 mm thick 316LN austenitic stainless steel in the vertical position was performed. The characteristics of droplet transfer, molten pool formation, and forming mechanism of different oscillating parameters were investigated by the experimental method. A high-speed camera was employed to observe the arc, droplet transfer, and molten pool formation. Results showed that the larger molten pool area, more intense fluid flow, and better weld bead formation were achieved when the oscillating laser joined to TIG as compared to TIG or normal laser-TIG hybrid welding. Due to the dynamic wire feed, the form of droplet transfer was mainly contact transfer, and the frequency of droplet transfer was equal to the frequency of wire feed and was independent of the parameters of the heat source. The electrical signals in the TIG and oscillating laser-TIG weld processes were collected, respectively, and the results showed that the change of conductivity might be the reason why the laser can compress the arc. The addition of laser increased the arc voltage and active power and improved the efficiency of hybrid welding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
