Abstract
The microstructure and properties of barium strontium titanate (BST) thin films grown by an in situ ultraviolet-assisted (UV-assisted) pulsed laser deposition (UVPLD) technique are reported in this paper. In comparison with BST films grown by conventional pulsed laser deposition (PLD) under similar conditions, but without UV illumination, the UVPLD-grown films exhibited improved structural, electrical, and optical properties. X-ray photoelectron spectroscopy showed that when exposed to atmosphere, Ba atoms from the outermost layers formed a thin layer of barium carbonate, which negatively affects the film electrical characteristics. UVPLD-grown films exhibited a smaller amount of Ba atoms within the carbonate layer, resulting in better electrical characteristics. The dielectric constant of 40-nm-thick films deposited at 650 °C by UVPLD and PLD were determined to be 281 and 172, respectively. The leakage current density of the UVPLD-grown films was in the mid-10-8 A/cm2 range, a factor of 2 lower than that obtained from PLD-grown films.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Applied Physics A: Materials Science & Processing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
