Abstract
Powdered dried peanut hulls were treated by one-step procedures to get activated carbon using chemical activation by H 3PO 4, ZnCl 2, KOH and thermal activation by steam pyrolysis. Products were characterized by adsorption of N 2 at 77 K and methylene blue (MB) from aqueous solution. Simple carbonization at 700–900 °C yields low adsorbing microporous carbons. Steam pyrolysis at 600 °C generates porosity in the mesopore range. KOH activation results in carbons of low surface area similar to steam pyrolysis, but with much developed mesoporosity, whereas ZnCl 2 activation yields a moderate adsorbing carbon, essentially microporous. Treatment with H 3PO 4 at increasing impregnation ratios creates abundant microporosity with extended surface area attaining a maximum at a ratio of 1.0. Considerable loss in porosity accompanies additional activating acid indicating the governing action of the amount of activant. A 50% diluted H 3PO 4 acid results in a carbon with considerable reduction in the internal porosity. Highest removal capacity of MB appears with H 3PO 4-activated carbons, whereas KOH-activated carbons show the weakest uptake for the dye.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.