Characteristics and oil absorption of deep‐fat fried dough prepared from ball‐milled wheat flour

Abstract

AbstractBACKGROUND: High levels of oil in fried products has been recognized as causing health problems. The formation of microstructure during frying is one factor that influences oil absorption. Above the glass transition temperature (Tg), the physical properties of a polymer influences the formation of structure. The ball‐milling process changes the physicochemical properties of wheat flour constituents. The present study investigated the effects of physicochemical changes in wheat flour by the ball‐milling process on structure formation and oil absorption in wheat flour dough model.RESULTS: Dough samples were made from wheat flour that had been ball‐milled for 0 to 10 h and then fried in frying oil at 150 °C for 1–7 min. Thermal properties of wheat flour, structure alteration, and textural properties of fried samples were evaluated. As compared with samples made of non‐milled flour, samples made from milled flour had smaller pores and higher oil absorption. The fracture force of a fried sample prepared from non‐milled flour was lower than that of a sample prepared from milled flour.CONCLUSION: Ball‐milling affected the microstructure formation in fried wheat flour dough, and subsequently oil absorption. The crispness of a sample prepared from non‐milled wheat flour is higher than that of a sample prepared from ball‐milled wheat flour. This may be due not only to a plasticization effect, but may also be dependent on microstructure. Copyright © 2008 Society of Chemical Industry