Abstract

A procedure for elemental composition determination of water-borne river particles (Po River) on both size-fractionated and unfractionated submicron particles (0.1–1 μm) by graphite furnace atomic absorption spectroscopy (GFAAS) and inductively coupled plasma-mass spectrometry (ICP-MS) is reported. Sample fractionation was performed using sedimentation field-flow fractionation (SdFFF). The distribution of relative mass vs. particle size was determined using UV detection. Fractions were collected over a narrow size range for scanning electron microscopy. With this combination of techniques the mass, elemental composition, and shape distributions can be obtained across the size spectrum of the sample. The size distributions of the major elements (Al, Fe) were determined by coupling both GFAAS and ICP-MS techniques to the SdFFF. The procedure was validated using a reference clay sample. Satisfactory agreement was found between both the GFAAS and ICP-MS aluminium signal and the UV detector signal. Some discrepancies were observed in the Fe Al ratios when comparing GFAAS and ICP-MS. Thus further investigation is in order to fully assess the role of SdFFF-ICP-MS and SdFFF-GFAAS techniques for elemental characterisation of aquatic colloids. Both GFAAS and ICP-MS signals unambiguously indicate a significantly higher Fe content in the lower size range, which is consistent with previous investigations. Trace element levels in unfractionated Po River particles, determined by both GFAAS and ICP-MS, show good agreement. The high levels of Cu, Pb, Cr and Cd found associated with the colloidal particles underlines the significance of the environmental role played by the suspended matter in rivers in both highly industrialised and intensively cultivated areas.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call