Abstract
Recently, Carbon Fiber Reinforced Thermoplastics (CFRTP) are expected to be used for lightweight component parts. To mold CFRTP, it is necessary to impregnate carbon fiber bundles with thermoplastic resin by heating the materials. We have been developing a low cost CFRTP molding technique in which direct resistance heating was applied to carbon fiber itself. When electrical current runs through the materials, they are heated by joule heat. Therefore this method can run with simple equipment and low consumed power. In our previous studies, flat plates and pipes of CFRTP have been molded by using direct resistance heating and the molding abilities have been evaluated. To use this molding method for automobile components, it is necessary to apply this method to three-dimensional molding. However, the temperature distribution of carbon fiber NCF has not been clarified when a direct resistance heating method is applied to three-dimensional molding. In this study, the heating properties of carbon fiber NCF formed at 90o and 120o by using direct resistance heating were evaluated, and angle plates were molded. By using direct heating to carbon fiber NCF the angle plates of CF/PA6 have been successfully molded in the condition for the holding time of 1 minute, the pressure of 2 MPa and heating temperature of 290°C.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call