Abstract
Temperature gradients in the thermally stratified fluid flowing through a pipe may cause undesirable excessive thermal stresses at the pipe wall in the axial, circumferential, and radial directions, which can eventually lead to damages such as deformation, support failure, thermal fatigue, cracking, etc., to the piping systems. Several nuclear power plants have so far experienced such unwelcome mechanical damages to the pressurizer surgeline, feedwater nozzle, high pressure safety injection lines, or residual heat removal lines at a pressurized water reactor (PWR). In this regard, determining with accuracy the transient temperature distributions in the wall of a piping system subjected to internally thermal stratification is the essential prerequisite for the assessment of the structural integrity of such a piping system. In this study, to realistically predict the transient temperature distributions in the wall of an actual PWR pressurizer surgeline with a complex geometry of three-dimensionally bent piping, three-dimensional transient computational fluid dynamics (CFD) calculations involving the conjugate heat transfer analysis are performed for the PWR pressurizer surgeline subjected to either out- or in-surge flows using a commercial CFD code. In addition, the wall temperature distributions obtained by taking into account the existence of wall thickness are compared with those by neglecting it to identify some requirements for a realistic and conservative thermal analysis from a safety viewpoint.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call