Abstract

With the development of cavitation, the high-energy pressure wave from a cavitation bubble collapsing is detrimental to the stable operation of centrifugal pumps. The present paper concentrates on pressure pulsations under cavitation conditions, and pressure amplitudes at the blade-passing frequency (fBPF) and RMS values in the 0–500 Hz frequency band are combined to investigate cavitation-induced pressure pulsations. The results show that components at fBPF always dominate the pressure spectrum even at the full cavitation stage. For points P1–P7 on the volute side wall, with a decreasing cavitation number, the pressure energy first remains unchanged and then it rises rapidly after the critical point. For point In1 in a volute suction pipe located close to the cavitation region, the pressure energy changes slightly at high cavitation numbers; then for a particular cavitation number range, the pressure energy decreases, and finally increases again. For different flow rates, the pressure energy at the critical point is much lower than the initial amplitude at the non-cavitation condition for In1. This demonstrates that the cavitation cloud in the typical stage is partially compressible, and the emitted pressure wave from a collapsing cavitation bubble is absorbed and attenuated significantly. Finally, this leads to the pressure energy decreasing rapidly for the measuring point In1 near the cavitation region.

Highlights

  • For centrifugal pumps, cavitation usually occurs in the blade channels, even at the volute tongue region, due to a drop in the inlet suction pressure [1,2]

  • The 3% head drop point is used to determine the full cavitation condition, and it is commonly defined as the critical net positive suction head (NPSHc)

  • The cavitation-induced pressure pulsation characteristics of a low specific speed centrifugal pump are investigated in the present paper

Read more

Summary

Introduction

Cavitation usually occurs in the blade channels, even at the volute tongue region, due to a drop in the inlet suction pressure [1,2]. Cavitation can have an effect on the pressure pulsation characteristics. Lu et al [11] investigated unsteady cavitation characteristics in a centrifugal pump, and pressure pulsations were extracted by placing a pressure transducer at the pump inlet suction. Cudina et al [20,21,22] investigated the noise characteristics of a centrifugal pump under cavitating flow conditions, and found that cavitation significantly affected discrete frequencies in the noise spectrum. Investigation of the pressure pulsation characteristics versus different cavitation stages is carried out, and the influence of cavitation on pressure pulsations in centrifugal pumps is revealed

Experimental set-up
24.2 Hz blade-passing frequency f BPF
Cavitation performance of the model pump
Cavitation-induced pressure pulsations
Visualization of cavitating flow
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call