Canopy fuel characteristics in relation to crown fire potential in pine stands: analysis, modelling and classification

Abstract

Crown fire occurrence and subsequent crown fire behaviour are strongly dependent on canopy fuel characteristics, especially canopy fuel load (CFL), canopy bulk density (CBD) and canopy base height (CBH). Therefore, quantification of such variables is required for the appropriate selection of silvicultural treatments aimed at reducing susceptibility to crown fire. Data from the IV Spanish National Forest Inventory and individual tree biomass dry weight equations were used to estimate the canopy fuel characteristics of four representative types of pine stands in north-western Spain. Probability of crown fire initiation and crown fire rate of spread were simulated by using the mean surface fuel load observed for each type of pine in this area and assuming different burning conditions. The results indicate that a 22.13 % of the sample plots analysed showed a rather high potential for active crown fire spread under moderate burning conditions, and this value increases to 69.27 % under extreme burning conditions. Equations relating the canopy fuel characteristics to common stand variables (stand density, basal area and dominant height) were fitted simultaneously for each pine, and weighting factors for heteroscedasticity were included. The models explained more than 93.90, 74.70 and 69.42 % of the observed variability in CFL, CBD and CBH, respectively. Basal area was the most important variable for estimating CFL and CBD while dominant height explained most of the observed variability in CBH. The use of the fitted equations together with existing dynamic growth models and fire management decision support systems will enable assessment of the crown fire potential associated with different silvicultural alternatives used in these types of pine stands.