Canola and high erucic rapeseed oil as substitutes for diesel fuel: Preliminary tests

Abstract

AbstractA cooperative project using the facilities of the POS Pilot Plant Corporation, the Saskatchewan Research Council and the Agricultural Engineering Department, University of Saskatchewan, and funded by Agriculture Canada, was initiated in 1980 to investigate the feasibility of using canola and high erucic rapeseed oil as a replacement/extender to diesel fuel in direct‐injection diesel engines. Work carried out included the documented production and refining of canola and R500 (high erucic) vegetable oils, preparation of methyl ester and of blends of all these fuels with methanol and ethanol. These fuels were evaluated by ASTM and improvised tests to determine their usefulness as diesel fuel. Engine tests involved a 2‐cylinder Petter diesel and a 6‐cylinder John Deere turbocharged diesel. Results were similar for both engines in short‐term performance tests, and indicated that: (a) maximal power was essentially the same when burning canola oil as when burning diesel fuel; (b) specific fuel consumption was ca. 6% higher when burning canola oil, but because canola oil has a heating value 14% less than diesel fuel, the thermal efficiency is somewhat higher when operating on canola oil; (c) there were no starting problems down to 10 C; (d) there were fewer particulates in the exhaust when burning canola oil; and (e) there was generally less combustion noise when burning canola oil. The high viscosity of canola oil (ca. 35 times that of disel fuel at 20 C) poses a major problem in using the oil at low temperature. Blending with diesel fuel and the creation of a methyl ester from the canola oil both proved effective in reducing viscosity, but neither lowered the pour point apprecibly. Efforts on reduction of pour points and further work on blends and on heating the fuel are described.