Abstract
The article of authors deals with the design of the structural part of the bodywork in the CAE system CATIA using the CAE software solutions of the Autoform system, which are based on the finite element method. This design was subsequently implemented into the design of dies in order to achieve the most efficient and high-quality dies, which are increasingly required in industrial practice for lifetime and functionality. Three types of high-strength steels TRIP HCT780T, DP-HCT780X and CP-HCT780C with approximately the same tensile strength were selected for the experiments. Based on the input parameters, simulations were implemented and the results obtained from the simulations will be the basis for selecting the most optimal variant. The main measurable and evaluative factor was the outputs obtained from the FLD diagrams.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.