Abstract
AbstractAntimony sulfide (Sb2S3) is a promising electrode material. However, its poor electronic/ionic conductivity severely hinders its practical application. Herein, carbon‐coated Sb2S3 nanorods (Sb2S3@C) are synthesized to address this issue. The electrochemical performance of the Sb2S3@C is evaluated in all‐solid‐state lithium batteries (ASSLBs) using InLi anode and Li10Si0.3PS6.7Cl1.8 solid‐state electrolytes. The Sb2S3@C cathode delivers the 1st cycle discharge capacity of 711 mAh g‐1 and a stable cycling capacity of 431 mAh g‐1, which are much higher than the 1st cycle discharge capacity of 125 mAh g‐1 and a stable cycling capacity of 320 mAh g‐1 for the uncoated Sb2S3 cathode. In situ transmission electron microscopy reveals that the carbon coating layer acts as an electronic/ionic conductive conduit, which boosts the charge transfer in the electrode dramatically. Consequently, the Sb2S3@C electrochemistry quickly evolves from intercalation to conversion to full alloying. However, the Sb2S3 nanorods without carbon coating undergo sluggish intercalation and conversion reactions, and the alloying reaction is almost impeded, severely limiting the capacity. Therefore, the Sb2S3@C electrode is fully utilized thus delivering much higher capacity and rate performance than the non‐coated Sb2S3 electrode. These results demonstrate that Sb2S3@C is a promising high‐energy‐density cathode for ASSLBs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.