Bone regeneration by recombinant human bone morphogenetic protein-2 in rat mandibular defects. An experimental model of defect filling.

Abstract

Bone defects and irregularities are major problems for dental implant and periodontal therapies. We investigated whether the application of recombinant human bone morphogenetic protein-2 (rhBMP-2) induces bone formation in through-and-through bone defects in the rat mandible. A round through-and-through bone defect (5 mm in diameter) was created in the angle of the mandible on both sides of the jaw using a steel round bur in each of 8 Long-Evans rats. In the experimental group, polylactic acid-polyglycolic acid copolymer/gelatin sponge (PGS) containing rhBMP-2 (6 microg/60 microl) was inserted in the bone defect. In the control group, the same carrier without rhBMP-2 was applied in the bone defect on the opposite side. Four weeks after application, the rats were sacrificed. Step serial sections stained with hematoxylin and eosin at intervals of 200 microm were prepared in a bucco-lingual direction. The size of the bone defects and new bone formation were evaluated histometrically. In all cases in the experimental group, a large quantity of newly formed bone was observed. The bone defects were completely filled with new bone in 4 of 8 rats in the experimental group. In the control group, small amounts of new bone formation were observed along the border of the original mandibular bone. Histometrical analysis revealed that the amount of new bone was significantly larger in the rhBMP-2 treated sites than in the control sites (P <0.0001; paired t-test). These results indicate that the rhBMP-2/PGS system induced effective bone regeneration on mandibular defects in rats. This procedure may be suitable as an experimental model for bone regeneration using various growth factors and effective for alveolar ridge augmentation followed by dental implant surgery.