Abstract
Abstract This paper presents an experimental study about the bonding quality of Maritime pine (Pinus pinaster Ait.) cross-layered wood elements glued with one-component polyurethane adhesive. The experiments comprised shear and delamination tests according to standard EN 16351 focusing on the influence of the following parameters: bonding pressure, adhesive spread rate, pre-treatment with primer and layer thickness. The results obtained show that increasing bonding pressure increases significantly the wood failure percentage after delamination or shear tests, while the delamination and the shear strength are not significantly affected. Moreover, it was found that the use of primer enhances significantly the bonding quality; nevertheless, EN 16351 requirements are fulfilled even for the lower bonding pressure and adhesive spread rate recommended by the manufacturer of the adhesive used in the experiments. The layer thickness, for the tested range, had no influence on the delamination and shear results and limited one on the wood failure percentage after shear or delamination tests. No relevant influence was found for the adhesive spread rate. In the experiments the combination of gluing Maritime pine with Australian blackwood (Acacia melanoxylon R.Br.) was also investigated and, for this combination, the standard requirements were successfully fulfilled.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
