Abstract
This study is to evaluate the bonding test between nanotube surface and machined dental titanium implant during the clinical procedure in beagle dog. A total of 24 screw-shaped implants (4 mm in diameter and 8.5 mm in length) were used. The implants were classified into 2 groups (n = 12): machined surface (M group) and nano surface which is nanotube formation on the machined surface (MA group). Anodic oxidation was performed at a 20 V for 10 min with 1 M H₃PO₄ and 1.5 wt% HF solutions. The implant were installed on beagle dog's humerus. After 4 and 12 weeks later, the beagle dog is sacrificed and the implant were removed with torque force. The removed implant was evaluated by SEM and EDX to observe the implant surface and nanotube's deformation. By investigating removed implant surfaces using SEM and EDX, M group was partially covered with bone, and MA groups were completely covered with bone. Nanotube was not shown any deformity. It indicated that nanotube showed good bonding stability with dental titanium implant.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.