Abstract
This research was conducted to investigate the bond strength between artificial teeth and a thermoplastic denture base resin for injection molding with different surface preparations for use in flexible resin removable partial dentures. Composite resin denture teeth and acrylic denture resin teeth were bonded to three types of thermoplastic denture base resins for injection molding (polyamide, polyester, and polycarbonate) and a conventional heat-polymerized polymethyl methacrylate (PMMA) resin (control). The ridge lap surfaces of the artificial teeth were classified into four groups based on the type of ridge lap surface treatment applied (n=10): no treatment, ethyl acetate, small T-shaped tunnel, and large T-shaped tunnel. The specimens were tested for bond strength. The results showed that the ethyl acetate treatment was ineffective for enhancing the bond strength (p>0.05) between the artificial teeth and thermoplastic denture base resin for injection molding, whereas the T-shaped tunnel was quite effective in this regard (p<0.05).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
