Abstract
BackgroundPatients with severely atrophied jaws can be challenging in implantology. The All-on-4 treatment concept eliminates advanced augmentation procedures in highly resorbed ridges by preserving the relevant anatomic structures. In addition, the inclination of the distal implants enables the placement of longer implants. Hence, tilting the anterior implants allows longer implant placement, in line with the distal implants of the All-on-4 concept. This study compared the biomechanical aspects of the standard All-on-4 treatment concept with the M-4 and V-4 techniques. MethodsA three-dimensional model of an edentulous maxilla was created to perform three-dimensional finite element analysis. Three different configurations (All-on-4, M-4, and V-4) were modeled by changing the tilt angle of the anterior implants. In each model, to simulate a foodstuff, a solid spherical material was placed on the midline of the incisors and the right first molar region, separately applying an occlusal load of 100 Newtons. The maximum principal stress and minimum principal stress values were acquired for cortical bone, and von Mises stress values were obtained for ductile materials. ResultsAccording to the present study's findings, although there were no considerable differences among the models, in general, the All-on-4 group demonstrated slightly higher stresses and the M-4 and V-4 group showed lower stresses. ConclusionM-4 or V-4 configurations may be used in cases of severely atrophied anterior maxillae to achieve better primary stabilization.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call