Biomechanical Assessment of Lumbar Stability: Finite Element Analysis of TLIF with a Novel Combination of Coflex, and Pedicle Screws

Abstract

Purpose Finite element analysis is frequently used for lumbar spine biomechanical analysis. The primary scope of this work is to illustrate, using finite element analysis, how the biomechanical behavior of the Transforaminal lumbar Interbody fusion (TLIF), along with a novel combination of the Interspinous process device (IPD) and pedicle screws, improves lumbar spine stability. Methods In this study, Unilateral Pedicle Screw Fixation (UPSF) and Bilateral Pedicle Screw Fixation (BPSF) were used. Four FE model was developed using ANSYS software, as follows: (1) Intact model; (2) TLIF with "U"-shaped Coflex-F IPD (UCF); (3) TLIF with Coflex-F and UPSF (UCF + UPSF); and (4) TLIF with Coflex-F and BPSF (UCF + BPSF). The intact model was subjected to four pure moments (10 Nm), and the results were validated with previous literature data. The intact model results correlated well with the literature data, and the model was validated. Three surgical models were subjected to 7.5 Nm four pure moments, Flexion (FL), Extension (ET), Lateral bending (LB), and Axial rotation (AR) and a 280N follower load. Results The surgical model results are compared with the intact model. The comprehensive analysis results show the UCF + BPSF surgical model gave a good advantage on range of motion, cage stress, Coflex-F stress, and endplate stress compared among the two models. Conclusions This study proposes that the UCF + BPSF system helps to reduce the stress on the implant and adjacent endplates and gives very good stability to the lumbar spine under the various static loading conditions.