Best practices for the measurement of 2-amino-2-methyl-1-propanol, piperazine and their degradation products in amine plant emissions

Abstract

We herein present the chemical-analytical setup used to measure atmospheric emissions of amines and amine degradation products from an amine-based post-combustion carbon capture plant. The emission measurements were carried out at the Technology Centre Mongstad (TCM) in Norway, in the frame of the ALIGN-CCUS campaign from September 2019 to January 2020, when the amine plant was operated with the CESAR 1 solvent. This advanced solvent is an aqueous solution of 2-amino-2-methyl-1-propanol (AMP) and piperazine (PZ). Four chemical-analytical techniques were deployed for characterizing emission of AMP, PZ and their degradation products: online Fourier Transform Infrared (FTIR) Spectroscopy, online Proton-Transfer-Reaction Time-of-Flight Mass Spectrometry (PTR-TOF-MS), online Proton-Transfer-Reaction Quadrupole Mass Spectrometry (PTR-QMS), as well as manual impinger sampling followed by offline Ion Chromatography Mass Spectrometry (IC-MS) analysis. AMP was detected by all four methods, with the results being in reasonably good agreement. PZ was detected by PTR-TOF-MS, PTR-QMS and IC-MS, but because of the low emission levels (single-digit ppb) the latter two methods suffered from a positive bias (due to an interfering compound) and a large measurement uncertainty, respectively. 17 amine degradation products were only detected by the PTR-ToF-MS analyzer. We present exemplary results from the emission measurements carried out during the ALIGN-CCUS 2019-2020 campaign and share some of the lessons learned from this exercise.