Abstract
This paper presents an investigation of lead-free Sn-Ag base alloy, 95.5Sn-3.9Ag-0.6Cu, both experimentally and analytically. Experimentally, the deformation behavior of the material was measured for different temperatures (25°C and 1000°C) over a range of strain rates (10−5 to 10−3/s) under isothermal and thermomechanical conditions. Development of a unified viscoplastic constitutive model followed, taking into account the effects of the measured strain rate and temperature changes. The temperature rate effects are considered in the evolution equation of back stress. In order to include material degradation in the solder, the theory of damage mechanics is applied by introducing two damage variables in the viscoplastic constitutive model. Finally, the constitutive model is coded into a general-purpose finite element computer program (ABAQUS) through its user-defined material subroutine (UMAT). The damage-coupled finite element analysis (FEA) is then employed to monitor the condition of failure of a notched component. The predicted and measured maximum loads have been compared and found to be satisfactory. In addition, the calculated damage distribution contours enable the identification of potential failure site for failure analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
