Beamforming of sound from two-dimensional arrays using spatial matched filters.

Abstract

Fully-sampled two-dimensional (2D) arrays can have two-way focusing of the ultrasound beam in both lateral directions leading to high quality, real-time three-dimensional (3D) imaging. However, fully-sampled 2D arrays with very large element counts (>16,000) are difficult to manufacture due to interconnect density and large element electrical impedance. As an alternative, row-column or crossed electrode arrays have been proposed to simplify transducer fabrication and system integration. These types of arrays consist of two one-dimensional arrays oriented perpendicular to each other. Using conventional delay-and-sum beamforming, each array performs one-way focusing in perpendicular lateral directions which yield higher sidelobe and acoustic clutter levels compared to fully-sampled 2D arrays with two-way focusing. In this paper, the use of spatial matched filters to improve focusing of row-column arrays is investigated. On receive, data from each element are first spatial match filtered in the elevation direction. After summation, the data are filtered again in the azimuth direction. Beam widths comparable to one-way focusing are seen in azimuth and beam widths comparable to two-way focusing are achieved in elevation. 3D beam patterns from computer simulation results using a 7.5 MHz 128 × 128 row-column array are shown with comparison to a fully sampled 2D array.