Abstract

Pine needle litter in Himalayan forests leads to forest fires, ground water recharge inhibition, soil acidification and contamination, and stops the growth of grass and plants. This study provides a possible solution for pine needle litter problem by converting it to biochar. Pine needle litter lying on the ground for approximately a month was collected from the Himalayan region. The pine needle litter biochars were generated using slow pyrolysis (residence time, 30 min; heating rate, 10 °C/min) at 350, 450, 550, 650, and 750 °C. Finally, pine needle litter biochar prepared at 550 °C (PNBC550) was selected for sorptive removal of aqueous lead both in batch and column studies. The PNBC550 was characterized for proximate and elemental compositions, crystallinity, surface area, morphology, and functional groups. A BET surface area of 230.9 m2/g was obtained for PNBC550. Batch sorption studies were carried out to study (1) the adsorption versus pH studies (at pH 2 to 7), (2) isotherms (at 10, 25, and 35 °C) to evaluate the temperature effect on the sorption efficiency, and (3) kinetics to reveal the effect of time, adsorbent dose, and initial concentration on the reaction rate. Increasing pyrolysis temperature raised lead sorption up to 550 °C. Lead adsorption increased considerably as pH rose from 2 to a maximum adsorption around pH 5 and above. The sorption data were fitted using different isotherm models and kinetic equations. The Langmuir adsorption capacity increased from 22.93 mg/g at 10 °C to 40.43 mg/g at 35 °C, showing that adsorption was endothermic. Fixed-bed studies were conducted at room temperature with an initial lead concentration of 7.85 mg/L and 4.0 g of PNBC550 at initial pH 5.0 and a flow rate of 3 mL/min. Desorption studies conducted under the same experimental conditions found about 90–93% lead recovery. Development of high-efficiency biochars for lead remediation provides a sustainable solution for the Himalayan pine needle litter problem. The biochars also possess the possible potential for aqueous removal of other metal cations.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call