Abstract
In order to optimize hot-working conditions of rapidly quenched Nd-Fe-Co-Ga-B magnets, the behavior of plastic deformation at elevated temperatures has been studied. Compressive and tensile tests were performed with various hot-working parameters. From compression tests, a strain-rate sensitivity factor and a strain hardening factor at 700 degrees C of 0.4 and 0.3, respectively, were obtained. From tensile tests, the tensile strength and elongation at 700 degrees C were determined to be 1.0 approximately 1.8 kgf/mm/sup 2/ and 6 approximately 12%, respectively. Based on these data, computer simulation of the die upsetting process was performed by rigid plastic FEM (finite-element method) calculation. It was found that, to suppress the occurrence of peripheral cracks and improve magnetic properties, low strain rates are necessary. Computer calculation of the stress distribution can explain the mechanism of peripheral crack initiation in the die upsetting process.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">></ETX>
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
