Abstract
Fluoropolymers have unique mechanical, chemical, and tribological properties (low friction coefficients) but their use as solid lubricants is inhibited by high wear rates (1–5×10−4 mm3/Nm). The addition of certain types of α-alumina has been shown to reduce the wear rate of PTFE by over three orders of magnitude, but due to its extremely high molecular weight PTFE cannot be screw injection molded. However, PFA, a perfluorinated copolymer of tetrafluoroethylene (TFE) and a perfluorinated alkylvinyl ether (PAVE), can be. Teflon® PFA 340 samples with various weight fractions of α-alumina (0%, 5%, 7.5%, 10%) were injection molded, and samples from each mold were wear tested against stainless steel (P=6.3 MPa, v=50.8 mm/s). Experiments showed that the friction behavior of the PFA 340-α alumina composite was very close to that of both unfilled PFA 340 and PTFE-α alumina composites. The wear rate of unfilled PFA 340 was 1.4×10−4 mm3/Nm, and dropped to 4.0×10−8 mm3/Nm for the PFA-α alumina composites. Just as in the case of PTFE-α alumina composites, these PFA composites generated brown-colored tribofilms on both the polymer and metal surfaces, which were indicative of tribochemical changes. ATR-IR and FTIR spectra of each surface showed evidence for the generation of perfluorinated carboxylate salts and waters of hydration. This spectral similarity between PTFE and PFA 340 samples shows that the same tribological mechanism found in PTFE-α alumina composites is responsible for ultralow wear in PFA-α alumina composites as well.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.