Abstract
Recently great interest has developed for a high speed, flexible machine vision system which can accurately determine solder paste and component placement for both process verification and quality control inspection. Present SMT inspection systems must cope with the unpredictable appearance of components and backgrounds and are often used only to determine presence and absence. This paper describes a new approach which combines greyscale data with a three‐dimensional map of the board under test. Originally this method was proposed as a robust technique for locating components in low contrast greyscale images. However, experience working with manufacturers and developers of placement equipment has shown that emerging SMT inspection requirements indicate the importance of three‐dimensional information. In addition to the detection of components and measurement of orientation, examples are shown of solder paste volume measurements, lead co‐planarity, and tombstone effect detection.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
