Abstract
AbstractA-plane (11-20) and diagonal cut (1-102) and (-110-2) surfaces of 4H-SiC have been investigated using atomic force microscopy (AFM), low-energy electron diffraction (LEED), Auger electron spectroscopy (AES), X-ray photoemission spectroscopy (XPS) and scanning tunneling microscopy (STM). After hydrogen etching the surfaces show large, flat terraces. On SiC(11-20) steps down to single atomic heights are observed. On the diagonal cut surfaces steps run parallel and perpendicular to the [-1101] direction, yet drastically different morphologies for the two isomorphic orientations are found. All surfaces immediately display a sharp LEED pattern. For SiC(1-102) and SiC(-110-2) the additional significant presence of oxygen in the AES spectra indicates the development of an ordered oxide. All three surfaces show an oxygen free, well ordered surface after Si deposition and annealing. A transformation between different surface phases is observed upon annealing.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
