Abstract
Atmospheric-pressure non-thermal plasmas have been increasingly promoted for polymer surface modifications. In this paper, atmospheric-pressure nitrogen plasma was used to render a polyester nonwoven fabric hydrophilic and facilitate absorption of a palladium catalyst in order to provide a catalytic surface for the deposition of electroless nickel. The plasma was produced in a surface barrier discharge generating a thin plasma layer in good contact with the fabric fibers. The optimum quality nickel coating was obtained for a 1 s treatment time. Treatment times in excess of 1 s resulted in a reduction of the nickel plating deposition rate, uniformity and adhesion values. The plasma-induced surface changes were characterized by liquid strike-through time measurements, X-ray photoelectron spectroscopy, and scanning electron microscopy. Because of atmospheric-pressure operation, very short treatment times, and its robustness the method has the potential to be used in line with standard metal plating lines.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.