Abstract

We experimentally studied the distribution of hip fracture types at different structural mechanical strength. Femoral neck fractures were dominant at the lowest structural strength levels, whereas trochanteric fractures were more common at high failure loads. The best predictor of fracture type across all failure loads and in both sexes was the neck-shaft angle. Bone geometry has been shown to be a potential risk factor for osteoporotic fractures. Risk factors have been shown to differ between cervical and trochanteric hip fractures. However, the determinants of cervical and trochanteric fractures at different levels of structural mechanical strength are currently unknown. In addition, it is not known if the distribution of fracture types differs between sexes. The aim of this experimental study on excised femora was to investigate whether there exist differences in the distribution of cervical and trochanteric fractures between different structural mechanical strength levels and different sexes and to identify the geometric determinants that predict a fracture type. The sample was comprised of 140 cadavers (77 females: mean age, 81.7 years; 63 males: mean age, 79.1 years) from whom the left femora were excised for analysis. The bones were radiographed, and geometrical parameters were determined from the digitized X-rays. The femora were mechanically tested in a side impact configuration, simulating a sideways fall. After the mechanical test, the fracture patterns were classified into cervical and trochanteric. The overall proportion of cervical fractures was higher in females (74%) than in males (49%) (p = 0.002). The fracture type distribution differed significantly across load quartiles in females (p = 0.025), but not in males (p = 0.205). At the lowest load quartiles, 94.7% of fractures in female and 62.5% in males were femoral neck fractures. At the highest quartiles, in contrast, only 52.6% of fractures in females and 33.3% in males were cervical fractures. Among geometric variables, the neck-shaft angle was the best predictor of fracture type, with higher values in subjects with cervical fractures. This finding was made in females (p < 0.001) and males (p = 0.02) and was consistent across all failure load quartiles. Femoral neck fractures predominate at the lowest structural mechanical strength levels, whereas trochanteric fractures are more common at high failure loads. Females are more susceptible to femoral neck fractures than males. The best predictor of fracture type across all structural strength levels and both sexes was the neck-shaft angle.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.