Abstract
High power fiber lasers are gaining increasing shares in the laser material processing market due to their many advantages over gas and solid-state lasers. The design approaches for the typical architectures used in continuous emission fiber lasers are revised and the impact of the different choices on the specifications of the cavity components are analyzed. Then, some results on the fabrication of key components for an all-fiber setup, such as pump (PCs) and signal combiners (SCs), are reported. Finally, an example of a high power module, suitable for the development of an over 4 kW system is presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
