Abstract
The optimal operating conditions of a combined dissolved air flotation (DAF)-microfiltration (MF) process to respond to changes in raw water quality were investigated by operating a pilot plant for two years. Without DAF pre-treatment (i.e., MF alone), MF operated stably with a transmembrane pressure (TMP) increase of 0.24 kPa/d when the turbidity of raw water was low and stable (max. 13.4 NTU). However, as the raw water quality deteriorated (max. 76.9 NTU), the rate of TMP increase reached 43.5 kPa/d. When DAF pre-treatment was applied (i.e., the combined DAF-MF process), the MF process operated somewhat stably; however, the rate of TMP increase was relatively high (i.e., 0.64 kPa/d). Residual coagulants and small flocs were not efficiently separated by the DAF process, exacerbating membrane fouling. Based on the particle count analysis of the DAF effluent, the DAF process was optimised based on the coagulant dose and hydraulic loading rate. After optimisation, the rate of TMP increase for the MF process stabilised at 0.17 kPa/d. This study demonstrates that the combined DAF-MF process responded well to substantial changes in raw water quality. In addition, it was suggested that the DAF process must be optimised to avoid excessive membrane fouling.
Highlights
As water contamination intensifies along with rapid industrial development and climate change due to global warming, numerous studies are being conducted to develop sustainable technologies for producing safe drinking water from contaminated source water with high turbidity, trace organic matter, toxic inorganic compounds, and colour/odourcausing materials [1,2]
The average dissolved organic carbon (DOC) concentration of the dissolved air flotation (DAF) effluent in this period was 1.8 mg/L (i.e., DOC removal was approximately 35%), while the DOC concentration measured in the NaOCl cleaning waste solution was 91 mg/L. These results indicate that fine organic flocs and unreacted coagulants not properly separated by the DAF process contributed to the increase in transmembrane pressure (TMP) during MF in the combined DAF-MF process (Figure 6)
The applicability of the combined DAF-MF process to respond to changes in raw water quality was demonstrated through a two-year pilot operation
Summary
As water contamination intensifies along with rapid industrial development and climate change due to global warming, numerous studies are being conducted to develop sustainable technologies for producing safe drinking water from contaminated source water with high turbidity, trace organic matter, toxic inorganic compounds, and colour/odourcausing materials [1,2]. The amounts of coagulants and chlorine used in the pre-treatment process to improve the sand filtration efficiency are high to ensure water safety, which has resulted in the occurrence of residual coagulants and disinfection by-products (DBPs) in treated water [3]. To resolve this problem, an advanced membrane filtration process has been introduced. Membrane filtration processes are rapidly being introduced for replacing rapid sand filtration due to their numerous advantages, such as simple equipment, automated operation, and water quality improvement [5]. As of 2017, 27 domestic membrane filtration plants have been introduced, with a total plant capacity of 442,080 m3 /d [6,7]
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
