Abstract
The effect on membrane fouling resistance during ultrafilration of oil/water emulsion with the presence of bentonite suspension is experimentally evaluated. The fouling resistance was analyzed as a function of different membrane types and bentonite concentration. The total membrane fouling was categorized into reversible and irreversible, by adopting an appropriate chemical cleaning technique. The results revealed a 40 % flux augmentation with the increase of bentonite concentration up to an optimum value of 300 mg l−1 for cellulose acetate membrane. Further increase of bentonite concentration led to particle deposition on the membrane surface and reduced the flux. The polysulfone membrane did not show a similar flux improvement. This could be due to its high hydrophobicity. The absorption of oil/water emulsion on bentonite increased TOC removal rate from 65% to 80%, and this effect was the major cause of reduction in gel layer formation on the membrane surface. The extent of irreversible fouling of the hydrophilic cellulose acetate membrane was much smaller than that of the polysulfone membrane. These experiments demonstrated that, presence of bentonite could induce transformation of irreversible fouling caused by oil emulsion to reversible fouling, which could be periodically chemically cleaned.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
