Abstract
Abrasive processing remains one of most demanded for hardened steels parts. Grinding of end surfaces of machines parts has become widespread due to the fact that it allows processing heat-treated surfaces more efficiently than turning and also correcting the surface geometry. This processing type is used almost mainly for finish processing operations of shafts ends, bearing rings, gears, etc. However, there is still no mathematical model for this processing type, which would satisfy most of the main technological parameters. In this article a mathematical model of the cutting force when grinding the shaft end by the grinding wheel end on circular grinding machines is obtained. Processing schemes for this grinding type are given and the calculated graph of the cutting force according to the obtained mathematical model is shown.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.