Abstract
Automatic manufacturing like machining centres can replace the worn cutting tool with a new edge in a short time within the setup time of a workpiece. In this situation no minimum-time speed exists as the usual machining. This paper aims to analyse the optimal machining speeds for this case under three kinds of evaluation criteria minimum time (or maximum productivity), minimum cost and maximum profit rate—and to investigate the relationship between the optimal machining speeds obtained. The efficiency speed range is also examined. An example is demonstrated to explain the analytical results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.