Abstract
With the influence of bedding plane, the mechanical properties of bedded rocks, such as shale and coal rock at vertical and parallel bedding direction show comparatively significant difference. Therefore, compared with homogeneous rocks, bedded rocks exhibit obvious anisotropic mechanical properties. Currently, most fracture initiation pressure prediction models simplify rock to homogeneous dielectric elastomer, which is inapplicable to calculate wellbore fracture initiation pressure at bedded stratums. Given that the mechanical properties of bedded rocks at bedding plane direction are the same, this paper established a calculation model of horizontal well fracture initiation pressure in the anisotropic formation and set up a numerical solution method of circumferential stress around the borehole by means of using boundary element method. In addition, a calculation method for fracture initiation pressure based on tensile strength criterion and simplex algorithm was also proposed. The research results indicate that: In the case of high elasticity modulus anisotropy ratio, the wellbore fracture initiation pressure is low; when the elasticity modulus at vertical bedding direction is greater than that at parallel bedding direction, fracture initiation pressure decreases with the increase of bedding dip angle; the shape of wellbore has imposed an significant influence on fracture initiation pressure. For non-circular wellbore, fracture initiation pressure increases with the increase of length-width ratio in the case of smaller ovality. When wellbore shape transforms from equiaxial circle to long and narrow ellipse, fracture initiation pressure decreases with the increase of stress concentration level. Thus, this paper performed calculation and comparison with classical solutions for particular cases similar to isotropic body of stratum using the model established which verified the validity of the proposed theory. According to the research results, a new method for precise calculation of fracture initiation pressure of horizontal well at bedded stratum was provided.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.