Abstract
In this paper the elastoplastic solutions with higher-order terms for apex V-notches in power-law hardening materials have been discussed. Two-term expansions of the plane strain and the plane stress solutions have been obtained. It has been shown that the leading-order singularity approaches the value for a crack when the notch angle is not too large. In plane strain cases the elasticity does not enter the second-order solutions when the notch opening angle is too small. For a large notch angle, the two-term expansions of the plane strain near-tip fields are described by a single amplitude parameter. The plane stress solutions generally contain the elasticity terms. The boundary layer formulations based on the small-strain plasticity theory confirm that a dominance zone exists ahead of the notch tip. Finite element results give good agreement to the asymptotic solutions under both plane strain and plane stress conditions. The second-order terms cannot improve the predictions significantly. The near-tip fields are dominated by a single parameter. Finite element calculations under the finite strain J2-flow plasticity theory revealed that the finite strains can only affect local characterization of the asymptotic solution. The asymptotic solution has a large dominance zone around the notch tip. For an apex notch bounded to a rigid substrate the leading-order singularity falls with the notch angle significantly more slowly than in the homogeneous material. It vanishes at the notch angle about 135° for all power-hardening exponents. The elasticity effects enter the second-order solutions when the notch angle becomes large enough. The tip fields are characterized by the hydrostatic stress and the shear stress ahead of the notch.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.