Analysis of crystallographic orientation and morphology of microstructure during hot working for an alpha/beta titanium alloy

Abstract

This work focuses on analysis of microstructure morphology and crystallographic orientation for Ti-17 alloy during hot working. The results show that alpha phase and beta phase influence each other and there is a coordinate deformation between them. The non-uniform deformation is observed under small deformation conditions. The observing area can be divided into small deformation zone (area L) and large deformation zone (area H). Both alpha and beta phases remain the initial morphology, and they have better capability of coordinate deformation in area L, while coordinate capability is weak in area H in which alpha phase is globularized. Correspondingly, the Burgers orientation relations are well preserved in area L, but the orientation relations are more or less destroyed in area H. Dynamic recovery is the main mechanism of beta phase evolution when height reduction is lower. By contrast, the continuous dynamic recrystallization (CDRX) of beta phase gradually dominates the deformation pattern as the deformation increases. An uniformly globularized alpha structure is obtained under large deformation condition. The unsynchronized rotation of alpha phase around <11−20> pole occurs during deformation, which leads to the uniform crystal structure inside the same alpha lamellae. This process is an important step of globularization of the lamellar structure.