Analysis of Accident Progression of Fukushima Daiichi NPP by the SAMPSON Code

Abstract

This paper describes analysis results of the early phase accident progression of the Fukushima Daiichi Nuclear Power Plant (NPP) Unit 1 by the severe accident analysis code SAMPSON. The isolation condensers were the only devices for decay heat removal at Unit 1, but they stopped after the loss of AC and DC powers. Since there were no decay heat removal for about 14 hours after their termination until the start of alternative water injection into the core by the fire engine, the core melt and the reactor pressure vessel (RPV) bottom failure occurred resulting in large amount of fission products release into the environment. The original SAMPSON was improved by adding new modellings for the phenomena which have been deemed specific to the Fukushima Daiichi NPP: (1) deterioration of SRV gaskets and (2) buckling of in-core-monitor housings which caused the early steam leakage from the core into the drywell, and (3) melt of the in-core-monitor housings in the lower plenum of the RPV. The analysis results showed that (1) 55.3% of UO2 of the initial loading and 66.1% of the core material including UO2, zircaloy, steel and control materials had melted down into the pedestal of the drywell, (2) the amount of Hydrogen generated by Zr-H2O reaction was 686 kg, (3) amount of Cs element released from fuels was 61 kg which was 72% of the total Cs element which was included in fuels at the initiation of the accident, and (4) 18.3% of the corium which fell into the pedestal was one large lump and the 81.7% was particulate corium.