Abstract
Acetamide is a potential genotoxic impurity; it should control in drug substance based on daily dosage level. It forms from base-contaminated acetonitrile and by-product of some drug substances. The available methods for acetamide in drug substance and water samples were determined by GC-MS using internal standard with critical procedures. These developed and validated methods can assist in evaluating the reaction between acetonitrile and different bases and also determine trace level acetamide in drug substances. The method development was initiated with DB-624, 30 m, 0.32 width and 1.0-μm column. The column was used to validate at the 600ppm TTC value. Similarly, the CP-SIL 5CB, 60 m, 0.32 width, the 5-μm column was used for the remaining TTC values. The validation study was performed for all TTC limits. The % RSD for precision at 600, 60, 20, 10 and 2.5ppm was <15%. The % recovery at all TTC level was in between the 70 and 130%. Solution stability study was performed up to the 24h. At 2.5ppm, the results were <15% variation from the initial value. The linearities from the 50 to 150% concerning TTC values were more than limit of 0.98 correlation coefficient. The limit of detection and limit of quantitation values were 0.4 to the 1.3ppm, respectively, for 2.5ppm TTC limit method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.