Abstract
This study presents a simple approach and its associated MATLAB toolbox for 3D block cutting and mesh cutting. The approach is suitable for the meshes of numerical methods including the Key Block Theory (KBT), the Discontinuous Deformation Analysis (DDA), the Numerical Manifold Method (NMM), and the cut Finite Element Method (Cut-FEM). The strategy is based on calculations on convex bodies. It uses two different forms of representation: the geometric representation which includes vertices and faces, and the algebraic representation which consists of inequalities. The cutting was implemented on the algebraic representation, and the resulting inequalities were converted into a geometric representation. The above strategy turned out to be robust and straightforward to execute, at the cost of a general body being regarded as a combination of convex bodies. The efficiency guarantee was considered through pre-checking algorithms. The source code was provided, as well as some simple examples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.