An MgO passivation layer and hydrotalcite derived spinel Co2AlO4 synergically promote photoelectrochemical water oxidation conducted using BiVO4-based photoanodes.

Abstract

MxCo3-xO4 co-catalysed photoanodes with high potential for improvement in PEC water-oxidizing properties are reported. However, it is difficult to control the recombination of photogenerated carriers at the interface between the catalyst and cocatalyst. Here, an ultra-thin MgO passivation layer was introduced into the MxCo3-xO4/BiVO4 coupling system to construct a ternary composite photoanode Co2AlO4/MgO/BiVO4. The photocurrent density of the electrode is 3.52 mA cm-2, which is 3.2 times that of BiVO4 (at 1.23 V vs. RHE). The photocurrent is practically increased by 0.86 mA cm-2 and 1.56 mA cm-2 in comparison with that of Co2AlO4/BiVO4 and MgO/BiVO4 electrodes, respectively. Meanwhile, the Co2AlO4/MgO/BiVO4 electrode has the highest charge separation efficiency, the lowest charge transfer resistance (Rct) and best stability. The excellent PEC performance could be attributed to the inhibitive effect provided by the MgO passivation layer that efficaciously suppresses the electron-hole recombination at the interface and drives the hole transfer outward, which is induced by Co2AlO4 to capture the electrode/electrolyte interface for efficient water oxidation reaction. In order to understand the origin of this improvement, first-principles calculations with density functional theory (DFT) were performed. The theoretical investigation converges to our experimental results. This work proposes a novel idea for restraining the recombination of photogenerated carriers between interfaces and the rational design of efficient photoanodes.