Abstract
In this work, machinability study during turning of Al-Mg2Si-Si is taken into consideration with varying cutting tools. Latin square method is applied to find out the effect of cutting velocity, feed as well as insert type onto force requirement. Results show that in relatively high cutting velocity range, feed has significant effect on forces. Under 60 –75 m/min cutting velocity with 0.06-0.08 mm/rev feed, good machinability is obtained, and hence, these cutting conditions may be recommended for application in the industry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
