Abstract
Composites have gained acceptance in an extensive range of applications owing to their unique characteristics. But, machining of these materials is often challenging due to improved bonding between matrix and fibre when fillers are added. Since the machinability is an important aspect for any material for its successful utilization, it is essential to analyse the effect of secondary phase on machinability. However, investigations on the effect of fillers on machinability of polymer composites are minimal. In this research, hybrid fillers, namely boron nitride (BN) and montmorillonite (MMT) nanoclay, were added to epoxy/glass fibre composite through compression moulding, in which quantity of MMT is fixed and BN is varied from 2 to 6 wt%. Abrasive water jet machining (AWJM) is a leading method for machining polymer composites in which transverse speed, stand-off distance, pump pressure and filler percentage are key factors and are considered as input variables. To assess the machinability, material removal rate (MRR), surface roughness (Ra) and kerf taper (Kt) are chosen as response variables. Experimental planning is done through Taguchi method, and Criteria Importance Through Intercriteria Correlation (CRITIC)-weighted Complex Proportional Assessment (COPRAS) technique is utilized for optimization. The results revealed that addition of BN reduces the MRR while it improves the surface finish and reduces the Kt. Transverse speed has the most influence over all the considered output responses, stand-off distance and water pressure mainly affect the MRR and Ra while filler addition mainly affects the Kt. The hybrid CRITIC-COPRAS approach–recommended optimal control factors resulted in 16.20 mm3/min MRR with 0.29° Kt and 3.86 µm Ra. The recommended optical condition can be utilized for effective machining of polymer composite with MMT/BN fillers.Graphical abstract
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
