Abstract
The principles of a new in-process measurement and control system for flatness errors in machining have been introduced. The laser-based system consists of a stylus, a geometrical table measurement system, and a forecasting compensatory controller. Through the application of the proposed system to simulated and actual cutting data it has been shown that improvements of flatness on the order of 80 percent are feasible.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.